DSC Alarm Battery Replacement Service by Technician

DSC alarms are often the go-to solution for many people and even businesses when it comes to security systems. Few can rival them for reliability and sophisticated features in the security system world. However, as the case is with any electronics that run on a backup battery during a power outage, over time, these batteries will deplete and require replacement to keep the system working properly. While it is possible to replace batteries manually, we feels that it is best to hire a qualified technician.

Why Should You Use a Technician for Changing the Battery?

While changing the battery on a DSC alarm panel may seem straightforward as it some considers yourself as simply unclip then reclip wires without worrying about what panel you have, but in reality, there are wires to handle, and you are actually working tactile inside your control panel, even if your alarm system notifies you of "wires" or any other faults and failures. A technician uses their qualifications, experience, as well as tools and to ensure that the replacement is completed correctly and safely.

The following are points in support of using a technician:

Correct Fault Diagnosis: A technician would ensure that the system reports that the fault is a dead battery and not an any other fault with the system as an example of a faulty wire, expired alarm, alarm falsely triggering, and could give you a better analysis of service worthiness of the system overall.

Correct Battery Selection: DSC uses 12V sealed lead-acid batteries, but the term sealed lead-acid battery may include variances in measurements, size, voltage, amperage, or even several facets of the battery. We should point out that a technician will ensure the correct one is installed.

Safe Installation: Professionals handling batteries through wiring know to handle their wiring carefully and are knowledgeable enough to reduce faults or damage to the system and prevent dangerous.

System Testing & Resetting: After the batteries are replaced, the technician will test the alarm system coupled with clearing the system of any alerts / trouble codes in the keypad.

Battery Disposal: A technician will remove the old battery and recycle it while observing all environmental laws.

What Will Happen During Service?

When you contact a technician, they will schedule a DSC alarm battery replacement service where they will:

1. Inspect the alarm unit to see any irregularities.

2. Disconnect and remove the older battery.

3. Install the replacement compatible battery.

4. It will be tested to check that it's working fine.

5. Clear any warning message from the control panel.

6. Provide maintenance suggestions and recommendations as necessary.

When to Replace the Battery

The typical lifespan of a DSC alarm battery is between 3 to 5 years. Below are signs of a battery that need to be replaced:

• Disturbing excessive beeping from the panel

• Multiple display "Low Battery" warnings

• The alarm system shuts down due to a power outage.

Final Thoughts

It is always nice to have the comfort in knowing that a technician provided your DSC alarm battery replacement service. You can be sure, the job will be done properly, and your security system will continue to be an operational service for you when needed. If your alarm system shows signs of battery trouble, it's time to schedule a service.